Network Settings; Sip Settings - Linksys SPA1001 Administrator User Manual

Chapter 5 Linksys ATA Field Reference
NAT Keep Alive Dest

Network Settings

Field
SIP ToS/DiffServ Value
SIP CoS Value [0-7]
RTP ToS/DiffServ Value
RTP CoS Value [0-7]
Auto PSTN Failback
Network Jitter Level
Jitter Buffer Adjustment

SIP Settings

Field
SIP Port
Document Version 3.2
Destination that should receive NAT keep alive messages. If the value is $PROXY,
the messages are sent to the current or outbound proxy.
The default is $PROXY.
Description
TOS/DiffServ field value in UDP IP packets carrying a SIP message.
The default is 0x68.
CoS value for SIP messages. (Not in PAP2T)
The default is 3.
ToS/DiffServ field value in UDP IP packets carrying RTP data.
The default is 0xb8.
CoS value for RTP data. (Not in PAP2T)
The default is 6.
If enabled, the SPA will automatically route all calls to the PSTN gateway when the Line
1 proxy is down (registration failure or network link down).
The default is yes.
Determines how jitter buffer size is adjusted by the Linksys IP phone. Jitter buffer size is
adjusted dynamically. The minimum jitter buffer size is 30 milliseconds or (10
milliseconds + current RTP frame size), whichever is larger, for all jitter level settings.
However, the starting jitter buffer size value is larger for higher jitter levels. This setting
controls the rate at which the jitter buffer size is adjusted to reach the minimum. Select
the appropriate setting: low, medium, high, very high, or extremely high.
The default is high.
Controls how the jitter buffer should be adjusted. Select the appropriate setting: up and
down, up only, down only, or disable.
The default is up and down.
Description
Port number of the SIP message listening and transmission port.
The default is 5060.
Linksys IP Phone Administrator Guide
Line Tab
5-35