Voip Users And Passwords (Http Authentication) - Linksys SPA1001 Administrator User Manual

Chapter 5 Linksys ATA Field Reference
Field
Line 1 Fallback DP
VoIP Caller ID Pattern
VoIP Access List
VoIP Caller 1/2/3/4/5/6/7/8 PIN
VoIP Caller 1/2/3/4/5/6/7/8 DP

VoIP Users and Passwords (HTTP Authentication)

Field
VoIP User 1/2/3/4/5/6/7/8 Auth
ID
VoIP User 1/2/3/4/5/6/7/8 DP
Document Version 3.2
Description
Index of the dial plan in the dial plan pool to be used when the VoIP Caller is calling from
Line 1 of the same SPA3102 unit due to fallback to PSTN service when Line 1 VoIP
service is down. Choose from {none, 1, 2, 3, 4, 5, 6, 7, 8}.
The default is 1.
A comma separated list of caller number templates such that callers with numbers not
matching any of these templates will be rejected for PSTN gateway service regardless of
the setting of the authentication method. The comparison is applied before access list is
applied. If this parameter is blank (not specified), all callers will be considered for PSTN
gateway service.
For example: 1408*, 1512???1234.
Note: '?' matches any single digit; '*' matches any number of digits.
The default is blank.
A comma separated list of IP address templates, such that callers with source IP address
matching any of the templates will be accepted for PSTN gateway service without further
authentication. For example: 192.168.*.*, 66.43.12.1??.
The default is blank.
One of 8 PIN numbers that can be specified to control access to the PSTN gateway by a
VoIP Caller, when the <VoIP Caller Authentication Method> is set to PIN.
The default is blank.
Index of the dial plan in the dial plan pool to be associated with the VoIP caller who enters
the PIN that matches <VoIP Caller 1/2/3/4/5/6/7/8 PIN>.
The default is 1.
Description
The first of 8 user-id's that a VoIP Caller can use to authenticate itself to the SPA using
the HTTP Digest method (in other words, by embedding an Authorization header in the
SIP INVITE message sent to the SPA. If the credentials are missing or incorrect, the SPA
will challenge the caller with a 401 response). The VoIP caller whose authentication
user-id equals to this ID is referred to VoIP User 1 of this SPA.
Note: If the caller specifies an authentication user-id that does not match any of the VoIP
User Auth ID's, the INVITE will be rejected with a 403 response.
The default is blank.
Index of the dial plan in the dial plan pool to be used with VoIP User 1.
The default is 1.
Linksys IP Phone Administrator Guide
PSTN Line Tab
5-59