Rtp300 - Linksys SPA1001 Administrator User Manual

Linksys Analog Telephone Adapters (ATAs)
Figure 1-5
The following tables describe the LEDS on the front panel and the ports on the back panel of the device.
Table 1-7
LED
Phone 1/2
Ethernet
Power
Table 1-8
Port
Phone 1/2
Ethernet
Power

RTP300

The RTP300 provides an ATA with two FXS ports along with an IP router (see
provides connectivity to an analog telephone as well as Internet connectivity to a LAN with a built-in
four-port switch. The IP router provides QoS support, an integrated firewall and VPN pass-through, and
full routing with DHCP and NAT.
Linksys ATA Administrator Guide
2-4
PAP2T
PAP2T Front Panel
Function
Steady green indicates active or registered connection to the ITSP through
the Phone port. Flashing indicates device is in use or off hook.
Steady green indicates active connection. Flashing indicates traffic.
Steady green indicates power on and Internet connection. Flashing indicates
not connected to the Internet, booting or firmware upgrade.
PAP2T Back Panel
Function
Connect to an analog telephone or fax machine with an RJ-11 cable.
Connect to a router or broadband (cable/DSL) modem.
Connect to the 5-volt DC power adapter.
Chapter 2 Getting Started
Figure 1-6). The RTP300
Document Version 3.1