Linksys SPA1001 Administrator User Manual page 111

Chapter 5 Linksys ATA Field Reference
Speed Dial Act Code
Secure All Call Act Code
Secure No Call Act Code
Secure One Call Act Code
Secure One Call Deact Code
Conference Act Code
Attn-Xfer Act Code
Modem Line Toggle Code
FAX Line Toggle Code
Referral Services Codes
Document Version 3.2
Assigns a speed dial number.
The default is *74.
Makes all outbound calls secure.
The default is *16.
Makes all outbound calls not secure.
The default is *17.
Makes the next outbound call secure. (It is redundant if all outbound calls are secure by
default.)
The default is *18.
Makes the next outbound call not secure. (It is redundant if all outbound calls are not
secure by default.)
The default is *19.
If this code is specified, the user must enter it before dialing the third party for a
conference call. Enter the code for a conference call.
If the code is specified, the user must enter it before dialing the third party for a call
transfer. Enter the code for a call transfer.
Toggles the line to a modem.
The default is *99. Modem pass-through mode can be triggered only by pre-dialing this
code.
Toggles the line to a fax machine. (Not in PAP2T)
The default is #99.
These codes tell the Linksys IP phone what to do when the user places the current call on
hold and is listening to the second dial tone.
One or more *code can be configured into this parameter, such as *98, or *97|*98|*123,
etc. Max total length is 79 chars. This parameter applies when the user places the current
call on hold (by Hook Flash) and is listening to second dial tone. Each *code (and the
following valid target number according to current dial plan) entered on the second
dial-tone triggers the Linksys IP phone to perform a blind transfer to a target number that
is prepended by the service *code.
For example, after the user dials *98, the Linksys IP phone plays a special dial tone called
the Prompt Tone while waiting for the user the enter a target number (which is checked
according to dial plan as in normal dialing). When a complete number is entered, the
Linksys IP phone sends a blind REFER to the holding party with the Refer-To target
equals to *98<target_number>. This feature allows the Linksys IP phone to hand off a call
to an application server to perform further processing, such as call park.
The *codes should not conflict with any of the other vertical service codes internally
processed by the Linksys IP phone. You can empty the corresponding *code that you do
not want to Linksys IP phone to process.
Linksys IP Phone Administrator Guide
Regional Tab
5-27