Gateway Accounts (Spa3102/Ag310) - Linksys SPA1001 Administrator User Manual

Chapter 5 Linksys ATA Field Reference
FAX T38 Redundancy
Fax Tone Detect Mode
FAX Tone Detect Mode
Symmetric RTP
References in this section to the SPA3102 also apply to the AG310.
Note

Gateway Accounts (SPA3102/AG310)

Field
Gateway1/2/3/4
GW1/2/3/4 NAT Mapping
Enable
GW1/2/3/4 Auth ID
GW1/2/3/4 Password
Document Version 3.2
Select the appropriate number.
The default is 1.
If you want the Gateway to detect the fax tone whether the Gateway is a caller or callee,
then select caller or callee. If you want the Gateway to detect the fax tone only if the
Gateway is the caller, then select caller only. If you want the Gateway to detect the fax
tone only if the Gateway is the callee, then select callee only.
This parameter has three possible values:
• caller or callee - SPA will detect FAX tone whether it is callee or caller
• caller only - SPA will detect FAX tone only if it is the caller
callee only - SPA will detect FAX tone only if it is the callee
•
The default is caller or callee.
(SPA3102 only) Enable symmetric RTP operation. If enabled, the SPA3102 sends RTP
packets to the source address and port of the last received valid inbound RTP packet. If
disabled (or before the first RTP packet arrives) the SPA3102 sends RTP to the destination
as indicated in the inbound SDP.
The default is yes.
Description
The first of 4 gateways that can be specified to be used in the <Dial Plan> to facilitate call
routing specification (that overrides the given proxy information). This gateway is
represented by gw1 in the <Dial Plan>. For example, the rule 1408xxxxxxx<:@gw1> can
be added to the dial plan such that when the user dials 1408+7digits, the call will be routed
to Gateway 1. Without the <:@gw1> syntax, all calls are routed to the given proxy by
default (except IP dialing).
The default is blank.
If enabled, the SPA will use NAT mapping when contacting Gateway 1.
The default is no.
This is the authentication user-id to be used by the SPA to authenticate itself to Gateway 1.
The default is blank.
This is the password to be used by the SPA to authenticate itself to Gateway 1.
The default is blank.
Linksys IP Phone Administrator Guide
Line Tab
5-45