Managing Caller Id Service - Linksys SPA1001 Administrator User Manual

Chapter 3 Configuring Linksys ATAs
•
•
Step 4 If faxes fail consistently, capture a copy of the web interface settings by selecting Save As > Web page,
complete from the administration web server page.
Step 5 Enable and capture the debug log. For instructions, refer to Item
Configuration FAQ"
Step 6 Identify the type of Fax machine connected to the ATA.
Step 7 Contact technical support.
If you are an end user of Linksys VoIP products, contact the reseller or Internet telephony service
provider (ITSP) that supplied the equipment.
If you are an authorized Linksys Voice System partner, contact Linksys technical support.

Managing Caller ID Service

The choice of caller ID (CID) method affects the following features:
•
•
•
Document Version 3.1
Loss
Delay
at the end of this chapter.
On Hook Caller ID Associated with Ringing – This type of Caller ID is used for incoming calls when
the attached phone is on hook. See figure below (a) – (c). All CID methods can be applied for this
type of CID.
On Hook Caller ID Not Associated with Ringing – This feature is used for send VMWI signal to the
phone to turn the message waiting light on and off (see Figure 1 (d) and (e)). This is available only
for FSK-based CID methods: (Bellcore, ETSI FSK, and ETSI FSK With PR).
Off Hook Caller ID – This is used to delivery caller-id on incoming calls when the attached phone
is off hook (see Figure 1-17). This can be call waiting caller ID (CIDCW) or to notify the user that
the far end party identity has changed or updated (such as due to a call transfer). This is available
only for FSK-based CID methods: (Bellcore, ETSI FSK, and ETSI FSK With PR).
Managing Caller ID Service
4. in "Troubleshooting and
Linksys ATA Administrator Guide
3-17