Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 90

Installing the Chassis in a Cabinet or Rack
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Figure 2-3
Position a person at each side of the chassis and one at the mechanical lift. Place the chassis on the lift
Step 5
by lifting on the top front of rear of the chassis.
Using the mechanical lift, lift the chassis up onto the rack-mount support brackets.
Step 6
Place the rear of the chassis on the rack-mount support brackets between the front mounting rails.
Step 7
Manually slide the chassis into the rack until it rests on the crossbar and the side rack-mount brackets.
Step 8
If you are installing the optional cable management brackets, place the cable management brackets in
Step 9
front of the right rack-mount brackets. Align the holes in the cable management brackets with the holes
in the front rack-mount brackets on the right and mounting rails, and then insert the screws.
Align the holes in the front rack-mount bracket with the holes in the mounting rails and insert the 12-24
Step 10
x 3/4-inch or 10-32 x 3/4-inch screws, using six screws per side. (See
Use a minimum of six screws to ensure that the switch is adequately supported.
Note
Cisco MDS 9500 Series Hardware Installation Guide
2-10
Securing the Rack-Mount Support Brackets
Chapter 2 Installing the Cisco MDS 9500 Series
Figure 2-4.)
OL-17467-02