Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 183

Chapter B Connecting the Cisco MDS 9500 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Figure B-1
Connecting the console port to a modem is supported for switches running Cisco MDS SAN-OS Release
Note
1.2(2a) or later or NX-OS Release 4.1(1b).
Caution The console port can be used to connect to a modem, however, we recommend using the COM1 port for
this purpose. If you decide to connect the console port to a modem, do not connect it while the switch is
booting; connect either before powering the switch on or after the switch has completed the boot process.
You can use the console port to perform the following functions:
•
•
•
•
To connect the console port to a computer terminal, the computer must support VT100 terminal
Note
emulation. The terminal emulation software—frequently an application such as HyperTerminal or
Procomm Plus—makes communication between the switch and computer possible during setup and
configuration.
OL-17467-02
Connecting to the Console Port on the Supervisor Module for the Cisco MDS 9500
Series
C o n s o le
Configure the Cisco MDS 9500 from the CLI.
Monitor network statistics and errors.
Configure SNMP agent parameters.
Download software updates.
Cisco MDS 9500 Series Hardware Installation Guide
Connecting to the Console Port
B-3