Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 89

Chapter 2 Installing the Cisco MDS 9500 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Figure 2-2 Positioning the Support Bars
1
1 Screws
2
Rack-mount support bracket
Once the support bars are installed, secure the rack-mount support brackets to the rack using the screws
Step 4
provided.
Note
OL-17467-02
3
2
1
3 Rack-mount support bar
If you are using the cable management bracket shipped with the switch, do not install the top
four screws to the front right side of the bracket. These will be installed after placing the cable
management bracket along that side. The bottom screw should be installed to support the front
of the rack-mount support bracket.
Installing the Chassis in a Cabinet or Rack
3
1
2
Cisco MDS 9500 Series Hardware Installation Guide
1
2-9