Installing the Chassis in a Cabinet or Rack
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Note
Figure 2-1
Step 3
Install one rack-mount support bar into the slots located on the rack-mount support brackets. Repeat this
for the other support bar.
Cisco MDS 9500 Series Hardware Installation Guide
2-8
If you are using the cable management bracket shipped with the switch, do not install the top
four screws into the front right of the bracket. However, you must install the bottom screw (see
Figure
2-1). The top four screws will be used to install the cable management bracket to the rail.
Positioning the Rack-Mount Support Brackets
Chapter 2
Installing the Cisco MDS 9500 Series
26.56 in
OL-17467-02