Removing And Installing The Power Supplies On The Cisco Mds 9513 Director; Removing An Ac Power Supply From The Cisco Mds 9513 Director - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual

Removing and Installing a Power Supply or PEM
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

Removing and Installing the Power Supplies on the Cisco MDS 9513 Director

The Cisco MDS 9513 power supplies are located at the rear of the chassis. The physical position of the
chassis in a rack will determine how you handle the power supply when removing or installing.

Removing an AC Power Supply from the Cisco MDS 9513 Director

Warning Voltage is present on the backplane when the system is operating. To reduce risk of an electric shock,
keep hands and fingers out of the power supply bays and backplane areas. Statement 166
To remove an AC power supply from the Cisco MDS 9513 Director, follow these steps:
Turn the power switch on the power supply to the off (0) position. There is an internal lock mechanism
Step 1
that prevents you from removing the power supply if it is not set to the off position.
Disconnect the power cable(s) from the power source.
Step 2
Loosen the screw on the cable retention device and disconnect the power cable from the power supply.
Step 3
Figure 2-27
Cable retention
Loosen all four 6-32 panel fasteners at the corners of the power supply.
Step 4
Cisco MDS 9500 Series Hardware Installation Guide
2-52
Cable Retention Device on the 6000W Power Supply
device
Chapter 2 Installing the Cisco MDS 9500 Series
OL-17467-02