Removing and Installing Fan Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Figure 2-38
Installing the Crossbar Module Fan Tray
To install a crossbar module fan tray, follow these steps:
Step 1
Remove the crossbar module fan tray from the bag if necessary.
Step 2
Orient the crossbar module fan tray in the chassis as follows:
a.
b.
c.
Cisco MDS 9500 Series Hardware Installation Guide
2-72
Removing a Crossbar Module Fan Tray
Position the module in the slot. (See
Slide the module carefully into the slot until the the fan tray is fully inserted into the chassis.
Tighten the two captive screws on the crossbar module fan tray to 8 in-lb screws.
Chapter 2
Figure
2-38.)
Installing the Cisco MDS 9500 Series
OL-17467-02