Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 211

Appendix C Cabinet and Rack Installation
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Installing the Cisco MDS 9500 Shelf Bracket Kit into a Cabinet or Rack
Figure C-3
Figure C-3
To install the shelf brackets in a cabinet or rack, follow these steps:
Step 1 Position a shelf bracket inside the rack-mounting rails as shown in
the front of the shelf bracket with the holes in the front rack-mounting rail, and then attach the shelf
bracket to the front rack-mounting rail using a minimum of four 1/4-20 screws.
Note
Align the screw holes at the back of the shelf bracket with the holes in the back rack-mounting rail, and
Step 2
then attach the shelf bracket to the back rack-mounting rail using a minimum of four 1/4-20 screws.
Repeat Step 1 and Step 2 with the other shelf bracket.
Step 3
Verify that the shelf brackets are at the same height (using the level or tape measure as desired).
Step 4
OL-17467-02
shows the installation of the Cisco MDS 9500 Shelf Bracket Kit into a four-post rack.
Installing the Shelf Bracket Kit into a Rack
The bottom hole of the shelf bracket should align with the bottom hole of a rack unit on the
rack-mounting rail (the hole immediately above the 1/2-inch spacing).
Figure C-3. Align the screw holes at
Cisco MDS 9500 Series Hardware Installation Guide
Cisco MDS 9500 Shelf Bracket
C-15