Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 140

Removing and Installing a Power Supply or PEM
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Figure 2-33
2
3
1 AC power connection
2 Power cable retainer
3 Power supply switch
Step 4 Grasp the power supply handle with one hand, place your other hand underneath the power supply, and
slide the power supply into the power supply bay. Ensure that the power supply is fully seated in the bay.
Step 5 Tighten the power supply captive screw to 8 in-lb.
Step 6 Plug the power cable into the power supply, and tighten the screw on the cable retention device to ensure
that the cable cannot be pulled out.
Note
Step 7 Connect the other end of the power cable to an AC power source.
Turn the power switch to the on (|) position on the power supply. Turning the power switch on also locks
Step 8
the power supply in the bay.
Step 9 Verify power supply operation by checking that the power supply LEDs are in the following states:
•
•
•
If the LEDs indicate a power problem, see the Cisco MDS 9000 Family Troubleshooting Guide. If you
cannot resolve an issue, contact your customer service representative.
Cisco MDS 9500 Series Hardware Installation Guide
2-60
2500-W AC Power Supply for the Cisco MDS 9509 Director
1
I
0
INPU T
FAN
OK
OK
4
5
The AC power cable for the 4000-W power supply is hardwired to the power supply.
INPUT OK LED is green.
FAN OK LED is green.
OUTPUT FAIL LED is off.
OUT PUT
FAIL
4 Captive screw
5 Power supply LEDs
Chapter 2 Installing the Cisco MDS 9500 Series
OL-17467-02