Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 173

Appendix A Migrating to Generation 3 8-Gbps Fibre Channel Switching Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Figure A-1
1
3
5
Place the MDS 9513 Fabric 1 module on an antistatic surface.
Step 9
On the MDS 9513 Fabric 2 module to be installed, ensure that the ejector levers are completely open.
Step 10
Step 11 Position the MDS 9513 Fabric 2 module in the chassis as follows:
a.
b.
OL-17467-02
Captive Screws and Ejector Levers on the Fabric Module
Captive screws
Fabric slot 1 label
Power LEDs
Position the module in the empty slot. Ensure that you align the sides of the module carrier with the
slot guides on each side of the slot.
Slide the module carefully into the slot until the EMI gasket along the top edge of the module
contacts the module in the slot above it and both ejector levers close to approximately 45 degrees
with respect to the front of the module. (See
Migration Procedures for the MDS 9513 Director
1
2
3
4
2
5
1
2
Ejector levers
4
Fabric slot 2 label
Figure A-2.)
Cisco MDS 9500 Series Hardware Installation Guide
A-7