Removing The Crossbar Module Fan Tray - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual

Chapter 2 Installing the Cisco MDS 9500 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Note

Removing the Crossbar Module Fan Tray

The crossbar module fan tray is designed to be removed and replaced while the system is operating
without presenting an electrical hazard or damage to the system, provided the replacement is performed
promptly. The crossbar module fan tray is used only in the Cisco MDS 9513 Director. It is installed at
the rear of the chassis and plugs into the back side of the midplane just above the crossbar modules.
To remove a crossbar module fan tray, follow these steps:
Step 1 Loosen the two captive screws on the fan tray.
Step 2 Hold the two captive screws and pull the fan tray out of the chassis using both hands.
Step 3 Take one hand and hold the face of the fan tray while supporting it with the other hand.
Pull the fan module clear of the chassis. (See
Step 4
OL-17467-02
If you purchased this product through a Cisco reseller, contact the reseller directly for technical
support. If you purchased this product directly from Cisco Systems, contact Cisco Technical
Support at this URL: http://www.cisco.com/warp/public/687/Directory/DirTAC.shtml.
Removing and Installing Fan Modules
Figure 2-37.)
Cisco MDS 9500 Series Hardware Installation Guide
2-71