Table of Contents
Advertisement
B.3.3 Pluggable Equipment Service State Transitions
Table B-5
Current Service State
OOS-MA,LPBK & MT
& OOG
OOS-MA,MT
OOG-MA,MT & OOG
1. For a VCAT cross-connect, an IS-NR to OOS-AU,AINS transition will not occur with a Loss of Multiframe (LOM) or
B.3.3 Pluggable Equipment Service State Transitions
The service state transitions for pluggable equipment are the same as for other equipment with the
exceptions listed in
Note
Pluggable equipment (pluggable interface modules [PIMs] and pluggable port modules [PPMs]) will
transition out of the UAS state when inserted if the software can read the EEPROM and identify
information on the pluggable equipment. If the software cannot read the pluggable equipment, the
equipment is considered invalid and will not transition out of the UAS state.
Table B-6
Current Service State
IS-NR
Cisco ONS 15454 Reference Manual, R8.5
B-10
ONS 15454 Port and Cross-Connect Service State Transitions (continued)
Action
Alarm/condition is raised.
Put the port or cross-connect in the IS
administrative state.
Put the port or cross-connect in the
IS,AINS administrative state.
Put the port or cross-connect in the
OOS,DSBLD administrative state.
Put the port or cross-connect in a
loopback.
Put the VCAT cross-connect in the
OOS,OOG administrative state.
Alarm/condition is raised.
Alarm/condition is raised.
Sequence Mismatch (SQM) condition on the member.
Table
B-6.
ONS 15454 Pluggable Equipment Service State Transitions
Action
Reset the pluggable equipment.
Provision an unsupported service rate.
Pluggable equipment does not work with
the board configuration.
Appendix B
Administrative and Service States
Next Service State
OOS-AUMA,FLT & LPBK &
MT & OOG
IS-NR
OOS-AU,AINS
OOS-MA,DSBLD
OOS-MA,DSBLD & OOG for a
VCAT cross-connect
OOS-MA,LPBK & MT
OOS-MA,MT & OOG
OOS-AUMA,FLT & MT
OOS-AUMA,FLT & MT & OOG
for a VCAT cross-connect
OOS-AUMA,FLT & MT & OOG
Next Service State
IS-NR
OOS-AU,MEA
78-18106-01
Advertisement
Table of Contents
