Ml100X-8 Port-Level Indicators; Cross-Connect And Slot Compatibility; Ml1000-2 Card; Table - Cisco 15454-DS1-14= - 1.544Mbps Expansion Module Reference Manual

5.8.2 ML100X-8 Port-Level Indicators

Table 5-15

Card-Level LEDs
FAIL LED (Red)
ACT LED (Green)
5.8.2 ML100X-8 Port-Level Indicators
The ML100X-8 card provides a pair of LEDs for each Fast Ethernet port: an amber LED for activity
(ACT) and a green LED for LINK.
Table 5-16
Port-Level Indicators
ACT LED (Amber)
LINK LED (Green)
Both ACT and LINK LED

5.8.3 Cross-Connect and Slot Compatibility

The ML100X-8 card operates in Slots 1 to 6 or 12 to 17 with the XC10G or XC-VXC-10G cards.

5.9 ML1000-2 Card

Note For hardware specifications, see the
The ML1000-2 card provides two ports of IEEE-compliant, 1000-Mbps interfaces. Each interface
supports full-duplex operation for a maximum bandwidth of 2 Gbps per port and 4 Gbps per card. Each
port autoconfigures for full duplex and IEEE 802.3x flow control.
SFP modules are offered as separate orderable products for maximum customer flexibility. For details,
see the
Figure 5-8
Cisco ONS 15454 Reference Manual, R8.5
5-20

ML100X-8 Card-Level Indicators

Description
The red FAIL LED indicates that the card processor is not ready or that a
catastrophic software failure occurred on the ML100-FX card. As part of the
boot sequence, the FAIL LED is turned on until the software deems the card
operational.
The green ACT LED provides the operational status of the ML100-FX. If the
ACT LED is green, it indicates that the ML100-FX card is active and the
software is operational.
ML100X-8 Port-Level Indicators
Description
A steady amber LED indicates a link is detected, but there is an issue
inhibiting traffic. A blinking amber LED means traffic is flowing.
A steady green LED indicates that a link is detected, but there is no
traffic. A blinking green LED flashes at a rate proportional to the level
of traffic being received and transmitted over the port.
Unlit green and amber LEDs indicate no traffic.
"5.14 Ethernet Card GBICs and SFPs" section on page
shows the ML1000-2 card faceplate and block diagram.
Table 5-16 describes the port-level indicators.
"A.7.10 ML1000-2 Card Specifications" section on page
Chapter 5
5-33.
Ethernet Cards
A-52.
78-18106-01