Xc-Vxc-10G Hosting Ds3Xm-6 Or Ds3Xm-12; Xc-Vxc-10G Card-Level Indicators; Table 2-18 Xc-Vxc-10G Card-Level Indicators - Cisco 15454-DS1-14= - 1.544Mbps Expansion Module Reference Manual

Chapter 2 Common Control Cards
Table 2-17
ONS 15454 VT Number
VT14
VT15
VT16
VT17
VT18
VT19
VT20
VT21
VT22
VT23
VT24
VT25
VT26
VT27
VT28

2.6.3 XC-VXC-10G Hosting DS3XM-6 or DS3XM-12

A DS3XM card can demultiplex (map down to a lower rate) M13-mapped DS-3 signals into 28 DS-1s
that are then mapped to VT1.5 payloads. The VT1.5s can then be cross-connected by the XC-VXC-10G
card. The XC-VXC-10G card can host a maximum of 1344 bidirectional VT1.5s.

2.6.4 XC-VXC-10G Card-Level Indicators

Table 2-18
Table 2-18
Card-Level Indicators
Red FAIL LED
ACT/STBY LED
Green (Active)
Amber (Standby)
78-18106-01
VT Mapping (continued)
Telcordia Group/VT Number
Group7/VT2
Group1/VT3
Group2/VT3
Group3/VT3
Group4/VT3
Group5/VT3
Group6/VT3
Group7/VT3
Group1/VT4
Group2/VT4
Group3/VT4
Group4/VT4
Group5/VT4
Group6/VT4
Group7/VT4
describes the two card-level LEDs on the XC-VXC-10G faceplate.
XC-VXC-10G Card-Level Indicators
Definition
Indicates that the cards processor is not ready. This LED illuminates during
reset. The FAIL LED flashes during the boot process. Replace the card if the
red FAIL LED persists.
Indicates whether the XC10G is active and carrying traffic (green), or in
standby mode to the active XC10G card (amber).
2.6.3 XC-VXC-10G Hosting DS3XM-6 or DS3XM-12
Cisco ONS 15454 Reference Manual, R8.5
2-27