Table of Contents
Advertisement
Chapter 5
Ethernet Cards
For information on the CE-100T-8 QoS features, refer to the "CE-100T-8 Operations" chapter of the
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration
Guide.
5.11.1 CE-100T-8 Card-Level Indicators
The CE-100T-8 card faceplate has two card-level LED indicators, described in
Table 5-21
Card-Level LEDs
SF LED (Red)
ACT LED (Green)
5.11.2 CE-100T-8 Port-Level Indicators
The CE-100T-8 card has two LEDs embedded into each of the eight Ethernet port RJ-45 connectors. The
LEDs are described in
Table 5-22
Port-Level Indicators
ACT LED (Amber)
LINK LED (Green)
Both ACT and LINK LED
OFF
5.11.3 Cross-Connect and Slot Compatibility
The CE-100T-8 card is compatible in Slots 1 to 6 or 12 to 17 with the XC10G, XC-VXC-10G, or XCVT
cards.
5.12 CE-1000-4 Card
For hardware specifications, see the
Note
78-18106-01
CE-100T-8 Card-Level Indicators
Description
The red FAIL LED indicates that the card processor is not ready or that a
catastrophic software failure occurred on the CE-100T-8 card. As part of the
boot sequence, the FAIL LED is turned on until the software deems the card
operational.
The green ACT LED provides the operational status of the CE-100T-8. When
the ACT LED is green, it indicates that the CE-100T-8 card is active and the
software is operational.
Table
5-22.
CE-100T-8 Port-Level Indicators
Description
A steady amber LED indicates a link is detected, but there is an issue
inhibiting traffic. A blinking amber LED means traffic flowing.
A steady green LED indicates that a link is detected, but there is no
traffic. A blinking green LED flashes at a rate proportional to the level
of traffic being received and transmitted over the port.
Unlit green and amber LEDs indicate no traffic.
"A.7.5 CE-1000-4 Card Specifications" section on page
5.11.1 CE-100T-8 Card-Level Indicators
Table
Cisco ONS 15454 Reference Manual, R8.5
5-21.
A-50.
5-27
Advertisement
Table of Contents
