Table 9-2 Ons 15454 Security Levels-Network View - Cisco 15454-DS1-14= - 1.544Mbps Expansion Module Reference Manual

Chapter 9 Security
Table 9-1 ONS 15454 Security Levels—Node View (continued)
CTC Tab Subtab
Audit
Test Access
DWDM
1. X indicates that the user can perform the actions.
—
2. indicates that the privilege to perform an action is not available to the user.
3. Provisioner user cannot change node name, contact, location, or AIS-V insertion on STS-1 signal degrade (SD) parameters.
4. The action buttons in the subtab are active for all users, but the actions can be completely performed only by the users with the required security levels.
Table 9-2
Table 9-2 ONS 15454 Security Levels—Network View
CTC Tab Subtab
Alarms —
Conditions —
History —
Circuits Circuits
Rolls
78-18106-01
[Subtab]:Actions
Retrieve
Archive
View
APC: Run/Disable/Refresh
WDM Span Check:
Edit/Retrieve Span Loss
values/Reset
ROADM Power Monitoring:
Refresh
PP-MESH Internal Patchcord:
Refresh
Install Without Metro Planner:
Retrieve Installation values
All Facilities: Mark/Refresh
shows the actions that each user privilege level can perform in network view.
[Subtab]: Actions
Synchronize/Filter/Delete
cleared alarms
Retrieve/Filter
Filter
Create/Edit/Delete
Filter/Search
Complete, Force Valid Signal,
Finish
9.2.1 User Privileges by CTC Action
Retrieve Maintenance Provisioning
— —
— —
X X
— X
X X
X X
X X
X X
X X
Retrieve Maintenance Provisioning
1
X X
X X
X X
2
— —
X X
— —
Cisco ONS 15454 Reference Manual, R8.5
Superuser
— X
X X
X X
X X
X X
X X
X X
X X
X X
Superuser
X X
X X
X X
X X
X X
X X
9-5