Enabling Keepalives - Cisco CSS11501S-C-K9 Configuration Manual

Chapter 4 Using the Configuration Manager

Enabling Keepalives

78-13124-06
Enter Privileged, Configuration, and SSL Configuration modes.
2.
SCA> enable
SCA# configure
(config[myDevice])# ssl
Enter Server Configuration mode for the desired server.
3.
(config-ssl[myDevice])# server myServer
(config-ssl-server[myServer])#
Disable SSL version 2.
4.
(config-ssl-server[myServer])# sslv2 disable
(config-ssl-server[myServer])#
Verify the active SSL/TLS versions for this server by entering the info
5.
command.
(config-ssl-server[myServer])# info
...
SSL version
...
6. Return to Privileged mode.
(config-ssl-server[myServer])# finished
SCA#
7. Save the configuration to flash memory. If not saved, the configuration is lost
during a power cycle or when the reload command is used.
SCA# write flash
SCA#
You can enable and configure keepalive "GET" messages between the virtual
servers on the device and hardware servers to which they refer. If no response is
received from the hardware server after specific number of failures (maxfailure),
the virtual server is marked as "suspended". When the hardware server comes back
online, the keepalive messages discover the server and mark it "active" again.
Cisco 11000 Series Secure Content Accelerator Configuration Guide
: v3 tls1
Enabling Keepalives
4-29