Cisco CSS11501S-C-K9 Configuration Manual page 60

Using the QuickStart Wizard
You have completed TCP service port configuration of the logical secure server
and are ready to specify a key to use.
The following ssl-server will be created.
Each ssl-server is associated with a key.
1. Key is stored in a file on a http or ftp server.
2. Want to use an existing or default Key.
Choose the option corresponding to your situation (1/2):
If you are using a key created with an IIS or non-PEM-encoded key
Note
or certificate, use the default keys and certificates included with SSL
device. After configuring the device with the QuickStart wizard, use
the configuration manager to load your own certificate and key. See
"Example: Setting up a Secure Server" in Chapter 4 and "SSL
Configuration Command Set" in Appendix C.
If you have the key available via a URL, type 1.
Enter the name of the key for ssl-server 'myServer':
Enter the name to assign a key. This name is used for identification only.
Key names can consist of Arabic numerals and upper- and lowercase
Note
alphabetic, underscore (_), hyphen (-), and period (.) characters. Key
names must begin with an alphabetic character and have a limit of
15 characters.
Enter the URL for a PEM encoded key file:
Cisco 11000 Series Secure Content Accelerator Configuration Guide
3-6
CONFIGURE SSL-SERVER 'myServer' KEY
SSL-Server name : myServer
Ip address : 10.1.2.3
Secure Port : 443
Clear Port : 80
Chapter 3 Using the QuickStart Wizard
78-13124-06