Cisco CSS11501S-C-K9 Configuration Manual page 64

Using the QuickStart Wizard
Type y to begin the server configuration process again with a new server. Type n
to set a configuration (enable) password for the device.
Would you like to set a password to protect configuration of the SCA?
(y/n):
Type y, and enter a password. Re-enter it to confirm.
You must set an enable password for the device to ensure its configuration
security. The password you enter is not displayed.
Would you like to set a name for this device? (y/n/q):
Type y, and enter a name for the SSL appliance.
A default gateway is needed to connect outside of your local subnet.
Would you like to set a default gateway for this device? (y/n/q): y
Enter a default gateway for this device:
A default gateway is needed for the device to connect outside of the local subnet.
Type y, and enter the IP address at the prompt.
A summary screen shows information about the device, keys, certificates, security
policies, and the logical secure servers configured on it.
SCA myDevice
Keys capacity 255, defined 3
-----------------------------------
-----------------------------------
Cisco 11000 Series Secure Content Accelerator Configuration Guide
3-10
SETUP CONFIGURATION PASSWORD PROTECTION
Name Id
default 1
default-512 2
default-1024 3
Chapter 3
RC V
0 Y
0 Y
0 Y
Using the QuickStart Wizard
78-13124-06