Configuring the Device
Note
Example: Configuring Secure URL Rewrite
Cisco 11000 Series Secure Content Accelerator Configuration Guide
4-12
Exit to Privileged mode and save the configuration to flash memory. If it is
5.
not saved, the configuration is lost during a power cycle or when the reload
command is used.
(config-ssl-rproxy[myRevServ])# finished
SCA# write flash
SCA#
When using this configuration, client browsers must be set to use this
device as a proxy.
The Secure URL Rewrite feature prevents URL redirects and references from
breaking or circumventing SSL sessions. This example uses the CLI. The same
options are available in the GUI.
1.
Open a management session with the device.
Enter Privileged, Configuration, and SSL Configuration modes:
2.
SCA> enable
SCA# configure
(config[SCA])# ssl
(config-ssl[SCA])#
Enter Server Configuration mode for the server you wish to configure URL
3.
rewrites.
(config-ssl[SCA])# server myServer
(config-ssl-server[myServer])#
The urlrewrite command uses the following syntax:
4.
urlrewrite <domainName> [sslport <portid>] [clearport <portid>]
<redirectonly>
Chapter 4
Using the Configuration Manager
78-13124-06