Installing A Firmware Image (Xmodem - Cisco CSS11501S-C-K9 Configuration Manual

Examples

Installing a Firmware Image (Xmodem)

Cisco 11000 Series Secure Content Accelerator Configuration Guide
D-6
Copy the firmware image file indicated in Table D-1 to the directory where
6.
Netcat is located.
Using the command console, change the active directory to the one where
7.
Netcat and the image file are located.
Enter the following command, substituting the IP address of the SSL device
8.
and appropriate firmware image filename if necessary.
nc -w 5 10.5.162.105 11768 <css-sca-2fe-k9.phz
On the SSL device's console, you should see a display similar to the
9.
following:
>>accepted netboot connection from 10.1.6.145:2056
transfer completed 1951970 bytes received
Image address:
Image length: 951826
Signed: yes
Image type: PHR/PHX file
csid: 0x460313d8
version: 0x00004000
system: 0x00000001
product: 0x00000005
arch: 0x00000007
type: 0x00000006
use zap to save to flash
Enter the following commands to save the image and restart the device.
10.
>>zap
>>boot
Messages are written to the console, indicating necessary files are written.
11.
The device will reboot into the serial console configuration manager.
This example uses the Xmodem to download the image to MiniMax over the
console serial line. The firmware image can be found on the distribution CD
accompanying the device and at the Cisco Web site.
Use the following table to identify the firmware image for use.
Appendix D
0x3a56350
MiniMax Command Summary
78-13124-06