Cisco CSS11501S-C-K9 Configuration Manual page 67

Chapter 3 Using the QuickStart Wizard
The list of SSL servers includes all those configured on the device. The columns
and their descriptions are shown in the table below.
Column
Name
Id
Secure SSL IP The IP address and TCP service port to monitor for SSL
Plaintext IP
KC
PKey
ST
Cert
Secpolicy
CA Group
You are asked whether to save the configuration to flash memory.
Would you like to save your configuration to flash? (y/n):
If you type y, you will be asked to wait while the configuration is saved to flash,
and the QuickStart wizard finishes. If you type n, the QuickStart wizard finishes.
Caution If the configuration is not saved to flash memory, the configuration
is lost during a power cycle or when the reload command is used.
78-13124-06
Description
The name of the SSL server
The number of the SSL server as loaded into the device
transaction requests
The IP address and TCP service port used to send decrypted
SSL traffic to the server
The validity of the key and certificate pair assigned to the SSL
server; "U" indicates the key or certificate is not defined, "Y"
indicates the key and certificate match, "N" indicates the key
and certificate do not match
The name of the private key assigned to the SSL server
Status: A (OK), I (incomplete or invalid), U (user-disabled), F
(FIPS-suspended), B (backend (hardware) server unavailable)
The name of the certificate assigned to the SSL server
The name of the security policy assigned to the SSL server
The name of the certificate chain, if one has been assigned to
the server
Cisco 11000 Series Secure Content Accelerator Configuration Guide
Using the QuickStart Wizard
3-13