Change Panel Port To Efb Port - ABB ACQ80 Firmware Manual



Change panel port to EFB port

You can use panel port as EFB port. To change panel port to EFB port, set
parameter
58.01 Protocol enable
changeover of the panel part to EFB port is success, the drive does not detect
control panel within 20 seconds. If the drive detects the control panel, remove
the control panel and reboot the drive again.
Cable connection diagram
Notes:
• When an external IO module (RIIO, BIO-01 etc) is connected to drive, this
changeover does not happen and only external IO is used for
communication.
• This feature is applicable only for R0-R2 frames.
to and restart the drive. If the
Modbus RTU
Program features 73