Table of Contents
Advertisement
340 Fault tracing
Fault / Aux. code
Code
(
aux code visible only on
(hex)
assistant control panel
and drive composer
000D
000E...0010
0011
0012
0013
FF63
STO diagnostics
failure.
FF81
FB A force trip
FF8E
EFB force trip
Cause
)
(Permanent magnet
motors only)
Second acceleration did
not finish within
reasonable time.
Internal error.
(Synchronous reluctance
motors only)
Pulse test error.
Motor too large for
advanced standstill ID
run.
(Asynchronous motors
only)
Motor data error.
SW internal malfunction.
A fault trip command has
been received through
fieldbus adapter A.
A fault trip command has
been received through
the embedded fieldbus
interface.
What to do
Contact your local ABB
representative.
Contact your local ABB
representative.
Contact your local ABB
representative.
Check that the motor and drive
sizes are compatible.
Contact your local ABB
representative.
Check that the motor nominal
value settings in the drive are the
same as in the motor nameplate.
Contact your local ABB
representative.
Reboot the control unit (using
parameter
96.08 Control board
or by cycling power.
boot
Check the fault information
provided by the PLC.
Check the fault information
provided by the PLC.
Advertisement
Table of Contents
