Timed Functions - ABB ACQ80 Firmware Manual

166 Parameters
No. Name/Value
Fault if running
32.57 Supervision 6
signal
32.58 Supervision 6
filter time
0.000 ...
30.000 s
32.59 Supervision 6
low
-21474836.00...
21474836.00
32.60 Supervision 6
high
-21474836.00...
21474836.00
32.61 Supervision 6
hysteresis
0.00...
100000.00
34

34 Timed functions

34.01 Timed functions
status
Bit Name
0 Timed function 1
1 Timed function 2
2 Timed function 3
3...15 Reserved
0000h...FFFFh
Description
Drive trips on fault
80B0 Signal supervision 1
motor is running.
Selects the signal to be monitored by signal
supervision function 6.
For the available selections, see parameter
Supervision 1 signal.
Defines a filter time constant for the signal
monitored by signal supervision 6.
Signal filter time.
Defines the lower limit for signal supervision 6.
Low limit.
Defines the upper limit for signal supervision 6.
Upper limit.
Defines the hysteresis for the signal monitored
by signal supervision 6.
Hysteresis.
Configuration of the timed functions.
See section
In the Manual In1P Start; In2 stop
mode, the drive starts with the pulse command from
the DI selected in the parameter 79.11 Manual input
source 1 and stops with the DI selected in the
parameter 79.12 Manual input source 2. This mode
can be used to start and stop the pump with two
separate push buttons.
Status of the combined timers. The status of a
combined timer is the logical OR of all timers
connected to it.
This parameter is read-only.
Description
1 = Active.
1 = Active.
1 = Active.
Status of combined timers 1...3.
on page 45.
Def/
FbEq16
if the 3
Zero
32.07
0.000 s
1000 = 1 s
0.00
-
0.00
-
0.00
-
-
1 = 1