Table of Contents
Advertisement
20 Startup, control with I/O and ID run
In an edit view:
• Use
and
right.
• Use
and
• Press
(Save) to accept the new
setting, or press
to the previous view without making
changes.
To give the drive a name that will be shown at
the top, press
If you do not want to change the default
name (ACQ80), continue straight to the set-
up of the motor nominal values by pressing
(Next).
Enter the name:
• To select the character mode (lower case /
upper case / numbers / special
characters), press
highlighted and then select the mode with
and
. Now you can start adding
characters. The mode remains selected
until you select another one.
• To add a character, highlight it with
and
, and press
• To remove a letter, press
• Press
(Save) to accept the new
setting, or press
to the previous view without making
changes.
to move the cursor left and
to change the value.
(Cancel) to go back
.
until symbol
.
.
(Cancel) to go back
is
Advertisement
Table of Contents
