Show Ip Access-Lists - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
An optional sequence number may be specified to indicate the order of this IP access list
relative to other IP access lists already assigned to this interface and direction. A lower
number indicates higher precedence order. If a sequence number is already in use for this
interface and direction, the specified access list replaces the currently attached IP access
list using that sequence number. If the sequence number is not specified for this command,
a sequence number that is one greater than the highest sequence number currently in use
for this interface and direction is used.
Default
Format
Modes
14.8.2.1 no ip access-group
This command removes a specified IP ACL from an interface.
Default
Format
Mode

14.8.3 show ip access-lists

This command displays an IP ACL
the IP ACL.
Format
Mode
Rule Number
Action
Protocol
Source IP
Address
Source IP Mask
Source Ports
14-34
none
ip access-group <accesslistnumber> in [sequence
<1-4294967295>]
Interface Config
Global Config
none
no ip access-group <accesslistnumber> in
Interface Config
<accesslistnumber>
show ip access-lists <accesslistnumber>
Privileged EXEC
This displays the number identifier for each rule that is
defined for the IP ACL.
This displays the action associated with each rule. The possi-
ble values are Permit or Deny.
This displays the protocol to filter for this rule.
This displays the source IP address for this rule.
This field displays the source IP Mask for this rule.
This field displays the source port for this rule.
v1.0, March 2006
is the number used to identify
Quality of Service (QoS) Commands