Show Ip Access-Lists; Show Access-Lists - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

14.8.3 show ip access-lists

This command displays an IP ACL
the IP ACL.
Format
Mode
Rule Number
Action
Protocol
Source IP
Address
Source IP Mask
Source Ports
Destination IP
Address
Destination IP
Mask
Destination Ports
Service Type Field
Match
Service Type Field
Value

14.8.4 show access-lists

This command displays IP ACLs and MAC access control lists information for a
designated interface and direction.
Format
Mode
ACL Type
14-38
<accesslistnumber>
show ip access-lists <accesslistnumber>
Privileged EXEC
This displays the number identifier for each rule that is
defined for the IP ACL.
This displays the action associated with each rule. The possi-
ble values are Permit or Deny.
This displays the protocol to filter for this rule.
This displays the source IP address for this rule.
This field displays the source IP Mask for this rule.
This field displays the source port for this rule.
This displays the destination IP address for this rule.
This field displays the destination IP Mask for this rule.
This field displays the destination port for this rule.
This field indicates whether an IP DSCP, IP Precedence, or IP
TOS match condition is specified for this rule.
This field indicates the value specified for the Service Type
Field Match (IP DSCP, IP Precedence, or IP TOS).
show access-lists interface <unit/slot/port> in
Privileged EXEC
Type of access list (IP or MAC).
v1.0, February 2007
is the number used to identify
Quality of Service (QoS) Commands