Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Default
Format
Mode
7.1.12.1 no netbios-name-server
This command removes the NetBIOS name server list.
Format
Mode
7.1.13 netbios-node-type
The command configures the NetBIOS node type for Microsoft Dynamic Host
Configuration Protocol (DHCP) clients.type Specifies the NetBIOS node type. Valid types
are:
•
b-node—Broadcast
•
p-node—Peer-to-peer
•
m-node—Mixed
•
h-node—Hybrid (recommended)
Default
Format
Mode
7.1.13.1 no netbios-node-type
This command removes the NetBIOS node Type.
Format
Mode
7.1.14 next-server
This command configures the next server in the boot process of a DHCP client.
Address is the IP address of the next server in the boot process, which is typically a TFTP
server.
Default
DHCP Commands
none
netbios-name-server <address>
[<address2>...<address8>]
DHCP Pool Config
no netbios-name-server
DHCP Pool Config
none
netbios-node-type <type>
DHCP Pool Config
no netbios-node-type
DHCP Pool Config
inbound interface helper addresses
v1.0, March 2006
7-7