Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
10.1.18.1 no snmp trap link-status
This command disables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See
Format
Mode
10.1.19 snmp trap link-status all
This command enables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled. See
Format
Mode
10.1.19.1 no snmp trap link-status all
This command disables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled. See
Format
Mode
10.2 SNMP Show Commands
This section describes the commands you use to view SNMP status and configuration
information.
SNMP Commands
'snmp-server enable traps linkmode' command).
no snmp trap link-status
Interface Config
Section 10.1.11 "snmp-server enable traps linkmode" on page 10-5
snmp trap link-status all
Global Config
Section 10.1.11 "snmp-server enable traps linkmode" on page 10-5
no snmp trap link-status all
Global Config
v1.0, March 2006
10-9