System Utility Commands; Traceroute; Clear Config; Section 15.2 "System Utility Commands - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
System Location
System Contact
System ObjectID
System Up Time
MIBs Supported

15.2 System Utility Commands

This section describes the commands you use to help troubleshoot connectivity issues and
to restore various configurations to their factory defaults.

15.2.1 traceroute

Use the
traceroute
traveling to their destination through the network on a hop-by-hop basis. The
value should be a valid IP address. The [port] value should be a valid decimal integer in
the range of 0(zero) to 65535. The default value is 33434.
The optional port parameter is the UDP port used as the destination of packets sent as part
of the traceroute. This port should be an unused port on the destination system.
Format
Mode

15.2.2 clear config

This command resets the configuration to the factory defaults without powering off the
switch. When you issue this command, a prompt appears to confirm that the reset should
proceed. When you enter
Format
Mode
System Maintenance Commands
Text used to identify the location of the switch. The factory
default is blank. To configure the system location, see
10.1.1 "snmp-server" on page
Text used to identify a contact person for this switch. The fac-
tory default is blank. To configure the system location, see
Section 10.1.1 "snmp-server" on page
The base object ID for the switch's enterprise MIB.
The time in days, hours and minutes since the last switch
reboot.
A list of MIBs supported by this agent.
command to discover the routes that packets actually take when
traceroute <ipaddr> [port]
Privileged EXEC
, you automatically reset the switch.
y
clear config
Privileged EXEC
v1.0, March 2006
10-1.
10-1.
<ipaddr>
Section
15-17