Set Igmp Maxresponse - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Format
Modes
13.1.4.1 no set igmp groupmembership-interval
This command sets the IGMPv3 Group Membership Interval time to the default value.
Format
Modes

13.1.5 set igmp maxresponse

This command sets the IGMP Maximum Response time for the system, on a particular
interface or VLAN. The Maximum Response time is the amount of time in seconds that a
switch will wait after sending a query on an interface because it did not receive a report for
a particular group in that interface. This value must be less than the IGMP Query Interval
time value. The range is 1 to 3599 seconds.
Default
Format
Modes
13.1.5.1 no set igmp maxresponse
This command sets the IGMP Maximum Response time (on the interface or VLAN) to the
default value.
Format
Modes
13-4
set igmp groupmembership-interval <vlanId> <2-
3600>
Interface Config
Global Config
VLAN Mode
no set igmp groupmembership-interval
Interface Config
Global Config
VLAN Mode
10 seconds
set igmp maxresponse <1-3599>
Global Config
Interface Config
VLAN Mode
no set igmp maxresponse
Global Config
Interface Config
VLAN Mode
v1.0, March 2006
IGMP Snooping Commands