Snmptrap; Snmptrap Snmpversion - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

10.1.14 snmptrap

This command adds an SNMP trap receiver. The maximum length of
sensitive alphanumeric characters. The
version parameter options are snmpv1 or snmpv2.
The parameter does not need to be unique, however; the
<name>
pair must be unique. Multiple entries can exist with the same
associated with a different
The reverse scenario is also acceptable. The
sending the trap to the receiver, but the
Community Table. For more information, see
on page 10-2.
Default
Format
Mode
10.1.14.1 no snmptrap
This command deletes trap receivers for a community.
Format
Mode

10.1.15 snmptrap snmpversion

This command modifies the SNMP version of a trap. The maximum length of
16 case-sensitive alphanumeric characters. The
snmpv2.
Note: This command does not support a "no" form.
Default
Format
Mode
SNMP Commands
<snmpversion>
.
<ipaddr>
<name>
is not directly associated with the SNMP
<name>
Section 10.1.2 "snmp-server community"
snmpv2
snmptrap <name> <ipaddr> [snmpversion <snmpver-
sion>]
Global Config
no snmptrap <name> <ipaddr>
Global Config
<snmpversion>
snmpv2
snmptrap snmpversion <name> <ipaddr> <snmpversion>
Global Config
v1.0, March 2006
<name>
is the version of SNMP. The
and
<name>
as long as they are
<name>
is the community name used when
can be snmpv1 or
is 16 case-
<ipaddr>
is
<name>
10-7