NETGEAR ProSafe GSM7212 Cli Reference Manual page 225

This section describes the system maintenance commands available in the 7200 Series
Managed Switch CLI.
The System Maintenance Commands section includes the following subsections:
• Section 15.1 "System Information and Statistics Commands" on page 15-1
• Section 15.2 "System Utility Commands" on page 15-17
• Section 15.3 "Logging Commands" on page 15-21
• Section 15.4 "CLI Command Logging Command" on page 15-26
• Section 15.5 "Configuration Scripting Commands" on page 15-27
The commands in this section are in one of four functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration
setting.
• Copy commands transfer or save configuration and informational files to and from the
switch.
• Clear commands clear some or all of the settings to factory defaults.
15.1 System Information and Statistics Commands
This section describes the commands you use to view information about system features,
components, and configurations.
15.1.1 show arp switch
This command displays connectivity between the switch and other devices. The Address
Resolution Protocol (ARP) cache identifies the MAC addresses of the IP stations
communicating with the switch.
Format
System Maintenance Commands
System Maintenance Commands
show arp switch
v1.0, March 2006
Chapter 15
15-1