Figure 57 Motion Detection; Table 17 Motion Detection Parameters - Honeywell 35 Series User Manual

Figure 57 Motion Detection

2. Configure the settings for the motion detection parameters.

Table 17 Motion Detection Parameters

Parameter
Channel
Enable
Event Actions
48
Description
In the Channel list, select a channel to set the motion detection.
Enable or disable the motion detection function. When enable the
function, the NVR is modified and the result can be synced to camera.
Push message to APP: enable a pop-up message to App which is
managing the NVR
Pop up message to monitor: enable a pop-up message in your UI
monitor.
Email: When an alarm occurs, the NVR device sends an email to the set
mailbox to notify the user. You need to set the email first. For details, refer
to Email.
Buzzer: activate the buzzer when an alarm occurs. The duration is set in
Event > General.
FTP: enable it to send snapshot to FTP path. Set FTP in Storage > FTP
interface.
PTZ: enable it and select the Channel and Preset. When an alarm occurs,
the NVR device associates the channel to perform the corresponding PTZ
action. For example, activate the PTZ in channel one to turn to the preset
point X.
•Tripwire alarm supports to activate PTZ preset point only.
•You need to set the corresponding PTZ actions first, see PTZ Control.
Full Screen: enable to show the live video of channel by full screen when
alarming.
Enable alarm out: enable to linkage alarm out, the parameters should be
set in Event > Alarm out interface. The alarm device (such as lights,
sirens, etc.) is connected to the alarm output port. When an alarm occurs,
the NVR device transmits the alarm information to the alarm device.
Enable camera alarm out: enable to linkage the alarm out port of camera.
Enable event recording: enable to record when the alarm is occur.
Honeywell 35 Series Network Video Recorder User Guide