Devices Connection - Honeywell 35 Series User Manual

Connect a VGA cable (not supplied) to the VGA interface and/or an HDMI
cable (not supplied) to the HDMI interface. Connect the other end to a
monitor (do not use a TV). Simultaneous VGA and HDMI output is
supported.
3. Connect the mouse
Connect the supplied USB mouse to the USB 2.0 interface.
4. Connect the Ethernet cable
Connect the supplied CAT5e Ethernet cable to the network port. Connect
the other end to a router on your network.
5. Connect audio devices (if applicable)
To record audio, connect the audio sources to the AUDIO IN connectors.
To play audio, connect an audio output device (low-impedance
headphones, speaker, or amplifier) to the AUDIO OUT connector.
6. Connect alarm devices (if applicable)
Connect alarm devices to the alarm in/out interface. If the alarm inputs
use external power, the device must have the same ground as the NVR.
7. Connect a PTZ camera (if applicable)
Your embedded NVR communicates with PTZ cameras through the
Network. Ensure that your camera is correctly connected to the Network.
8. Connect the power cable
Connect the supplied 12 V DC (Depend on models, DC12V(3A) /DC 52V
/AC 220V please refer to actual product) power adapter to the power input.
Use of an uninterruptible power supply (UPS) is strongly recommended.

Devices Connection

The following diagram shows a typical NVR connection:
14
Honeywell 35 Series Network Video Recorder User Guide