Toshiba e-STUDIO2008A Service Manual page 488

7.3 General Descriptions for PM Procedure
Perform the preventive maintenance in the following timing.
• 20ppm: every 80,000 sheets
• 25ppm: every 100,000 sheets
• 30ppm: every 120,000 sheets
• 35ppm: every 125,000 sheets
• 45ppm: every 150,000 sheets
• 50ppm: every 150,000 sheets
(1) Preparation
• Ask the user about the current conditions of the equipment and note them down.
• Before starting maintenance, make some sample copies and store them.
• See the replacement record and check the parts to be replaced in the 20 PM Support Mode or
30 List Printing Mode.
20 PM Support Mode: Performs FS-20
30 List Printing Mode: Performs FS-30-103
PM SUPPORT CODE LIST
20xx -04-09 13:16
UNIT
DRUM
DRUM BLADE
GRID
NEEDLE ELECTRODE
SEPARATION FINGER (DRUM)
RECOVERRY BLADE
DEVELOPER
TRANSFER ROLLER
OZONE FILTER
FUSER ROLLER
PRESS ROLLER
SEPARATION FINGER (FUSER)
PICK UP ROLLER (1st CST.)
FEED ROLLER (1st CST.)
SEP ROLLER (1st CST.)
PICK UP ROLLER (2nd CST.)
• Turn OFF the power and make sure to unplug the equipment.
(2) Perform a preventive maintenance using the following checklist and illustrations. Refer to the
Service Manual if necessary.
(3) Plug in the equipment after the maintenance has been finished. Then turn ON the power and
make some copies to confirm that the equipment is working properly.
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
PREVENTIVE MAINTENANCE (PM)
S/N : Cxxxxxxxx FIN S/N : FIN S/N-xxxxxxxx
TOSHIBA e-STUDIOxxxx
OUTPUT PAGES PM OUTPUT PAGES
DEVELOP COUNTS DEVELOP COUNTS
1957
1957
1957
1957
1077
1077
1077
1077
1077
1077
1077
1077
1077
1077
1077
1077
Fig. 7-1
7 - 4
TOTAL : 2146
DF TOTAL
DRIVE COUNTS PM DRIVE COUNTS
1957 10870
1957 10870
1957 10870
1957 10870
1077 3766
1077 3766
1077 3766
1077 3766
1077 3766
1077 9547
1077 9547
1077 9547
1077 9547
1077 9547
1077 9547
1077 9547
© 2015 TOSHIBA TEC CORPORATION All rights reserved
: 1213
170000
170000
170000
170000
170000
170000
170000
170000
170000
170000
170000
170000
170000
170000
170000
170000