Toshiba e-STUDIO2008A Service Manual page 915

[K] Reinstall license
If the license was returned in "[B]Return License", reinstall it with the following procedure.
(1) Performs FS-05-3840.
(2) Press the [INSTALL].
(3) Install the one-time dongle in the equipment (the one which you used for returning the selected
license before replacing the equipment). Then press the [OK].
(4) Select the license to be installed, and then press the [INSTALL].
(5) The screen for notifying that the installation will be started is displayed. Then press the [YES].
(6) After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK]. If the screen for notifying a failure of the performance is
displayed, quit this operation by pressing the [NO]. Then check that the one-time dongle is
installed properly in the equipment.
(7) Check that the installed license is displayed on the license list.
Remarks:
• If there are any other licenses to be installed, repeat from step (2).
• If there are no other licenses to be installed, press the [CLOSE], and then turn the power OFF.
[L] Enable HDD encryption
If the HDD encryption function is used, follow the procedure below.
(1) Performs FS-05-8911.
(2) Enable the encryption function.
• For high security mode
Set the value of FS-08-8911 to "3".
• For enabling HDD encryption only
Set the value of FS-08-8911 to "1", and then set the value of FS-08-9379 to "1" (Security
priority) or "2" (Performance priority).
(3) Turn the power OFF.
[M] Adjust image quality
(1) Performs FS-05-3203 (Data transfer of characteristic value of scanner).
(2) Performs FS-05-7165 (Automatic gamma adjustment" <PPC>).
 P. 6-23 "6.4.1 Automatic gamma adjustment"
(3) Turn the power OFF.
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
9 - 31
REPLACEMENT OF PC BOARDS/HDD
9