Toshiba e-STUDIO2008A Service Manual page 469

[ 1-5 ] Paper exit tray switching settings
Set the switching timing of the paper exit from the movable tray to the finishing tray.
If the problem is not suppressed through Steps [1-1] to [1-4], perform the following steps.
(1) Turn OFF the power of the equipment.
(2) Remove 1 screw and take off the board access cover [1].
(3) Set the SW1 on the Finisher control board as shown in the figures below.
(4) Turn ON the power of the equipment while pressing the [FUNCTION CLEAR] button and
[START] button simultaneously.
(5) Press [Button1] 11 times and then press [Button2] once.
(6) Press [Button1] 13 times and then press [Button2] once.
(7) Check the following list and press [Button1] as many times as noted for Adjustment value whose
switching timing you want to select.
Approx. 500 sheets with plain paper
0 sheet with plain paper
(8) Press [Button2] once.
(9) Press [Button1] and [Button2] simultaneously.
(10) Turn OFF the power of the equipment.
(11) Turn OFF all bits of SW1 on the Finisher control board as shown below.
(12) Install the board access cover with 1 screw.
© 2015 TOSHIBA TEC CORPORATION All rights reserved
[1]
Fig.6-87
Switching timing
ON SW1
1 2 3 4
Fig.6-88
6 - 85
SW1
ON
1 2 3 4
SW1
Number of blinking times
1
3
ON SW1
1 2 3 4
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SETTING / ADJUSTMENT
6