Toshiba e-STUDIO2008A Service Manual page 480

[ 2 ] Folding position adjustment
(1) Turn OFF the power of the equipment.
(2) Remove 2 screws and take off the board access cover [1].
(3) Set the SW1 on the Finisher control board as shown in the figures below.
Turn ON pin 1 and 4.
(4) Turn ON the power of the equipment while [FUNCTION CLEAR] button and [START] button are
pressed simultaneously.
(5) Press [Button 1] on the touch panel 10 times and then press [Button 2] once. Then press [Button
1] again 2 times, and [Button 2] once again. (Adjustment of LD and A3 paper starts.)
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SETTING / ADJUSTMENT
Fig.6-104
LED3 LED2
Button1
Fig.6-105
6 - 96
[ 1 ]
LED1
Button2
© 2015 TOSHIBA TEC CORPORATION All rights reserved