Toshiba e-STUDIO2008A Service Manual page 913

[F] Clear SRAM update Error flags
(1) Performs FS-73.
(2) After "Firmware Assist Mode" is displayed on the LCD, check that "1: Clear Error Flag in Software
Installation." is marked and press the [START] Key.
If not, key in [1] and then press the [START] Key.
(3) When "Operation Complete" is displayed on the LCD, clearing the flag is completed.
(4) Turn the power OFF.
[G] Backup ADI key
If the ADI-HDD is installed, follow the steps below. To confirm the type of device, start up the equipment
in HS-74.
(1) Performs FS-73.
(2) Press the [Key Backup/Restore].
(3) Press the [ADIKey] and then [Execute].
(4) Wait until the backup of the ADI key is completed. "Success" is displayed.
(5) Restart the equipment after the backup is completed.
If you want to perform the backup of the license, do not restart the equipment but perform from
(3) in "[H] Backup encryption key".
[H] Backup encryption key
(1) Performs FS-73.
(2) Press the [Key Backup/Restore].
(3) Press the [Key] and then [Execute].
(4) Wait until the backup of the encryption key is completed. "Operation Complete" is displayed.
(5) Restart the equipment after the backup is completed. If you want to perform the backup of the
license, do not restart the equipment but perform from (3) in "[I] Backup license".
(6) Turn the power OFF.
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
9 - 29
REPLACEMENT OF PC BOARDS/HDD
9