Toshiba e-STUDIO2008A Service Manual page 755

MJ-1106/1108
Check Item
Paddle
Paddle motor (M8)
Replacement part
Paddle motor (M8)
Finisher control PC board
[CF10] Communication module SRAM reading failure
Classification
Finisher related service call
MJ-1101/1107
Check Item
Main power switch
Setting of the equipment
Converter PC board
Finisher control PC board
Replacement part
Converter PC board
Finisher control PC board
MJ-1101 (When MJ-6103 is installed) / MJ-1107 (When MJ-6104 is installed)
Check Item
Main power switch
Setting of the equipment
Converter PC board
Finisher control PC board
Hole punch control PC board
Replacement part
Converter PC board
Finisher control PC board
Hole punch control PC board
© 2015 TOSHIBA TEC CORPORATION All rights reserved
Rotate the paddle.
Fix any mechanical problem.
Check if the connector (CN22) on the finisher controller PC
board is disconnected from the paddle motor (M3) and the
harnesses are open circuited. Correct if so.
Communication module SRAM reading failure.
Turn OFF the main power switch, then back ON.
Check if the MJ-1101/1107 is set as the specified finisher on the
equipment. (08-4548)
• Check the connectors and harnesses between the converter
PC board and the finisher controller PC board.
• Board check
Board check
Turn OFF the main power switch, then back ON.
Check if the MJ-1101/1107 is set as the specified finisher on the
equipment. (08-4548)
• Check the connectors and harnesses between the converter
PC board and the finisher controller PC board.
• Board check
• Check the connectors and harnesses between the hole
punch control PC board and the finisher control PC board.
• Board check
Board check
8 - 217
Measure
Measure
Contents
Measure
Measure
Measure
Measure
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
8