Toshiba e-STUDIO2008A Service Manual page 918

9.2.10 Firmware confirmation after the PC board/HDD/SSD replacement
After replacing the PC board/HDD/SSD, check the firmware version in the setting mode (08) and
confirm if the firmware combination is correct.
System software
System firmware
Engine firmware
Scanner firmware
NIC firmware
DF firmware
PFC firmware
Finisher firmware
Hole Punch Unit firmware
FAX board firmware (Line1)
FAX board firmware (Line2)
The installed ROM versions and the registered optional Electronic License Keys can be confirmed in
the list print mode following the procedure below.
(1) Perform [FS-30-111] to print out VERSION LIST.
* It is recommended to keep this list for future reinstallation such as the replacement of the SYS
board.
(2) Keep pressing the [ON/OFF] button until you hear a sound to shut down the equipment.
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
REPLACEMENT OF PC BOARDS/HDD
Firmware
© 2015 TOSHIBA TEC CORPORATION All rights reserved
9 - 34
Code
9900
9930
9901
9902
9990
9903
9940
9904
9944
9905
9969