Toshiba e-STUDIO2008A Service Manual page 739

[CBB0]Rear saddle stapler home position error
MJ-1106/1108
Classification
Finisher related service call
Check item
Rear saddle stapler clinch unit
Saddle control PC board (SDL)
Replace parts
Rear saddle stapler clinch unit
Saddle control PC board
[CBC0] Saddle Stitch Finisher side alignment motor (M15) abnormality
MJ-1106/1108
* You receive a [CBC0] error when the [EF15] error occurs three times in succession.
Classification
Finisher related service call
Check Item
Saddle Unit
Side alignment motor (M15)
Saddle control PC board (SDL)
Replacement part
Side alignment motor (M15)
Saddle control PC board (SDL)
[CBC0] Saddle stitch alignment motor (M8) abnormality
MJ-1033
Error
Saddle stitch alignment motor
Saddle stitch alignment plate home
position sensor
Probable cause
Saddle stitch alignment motor (M8)
abnormality
© 2015 TOSHIBA TEC CORPORATION All rights reserved
Harness check
• Connector check (CN7)
• Board check
If there is mechanical problem when the jog is moved, fix the
mechanism.
Harness check
• Connector check (CN7)
• Board check
Timing of detection
The turning OFF of the saddle stitch alignment plate home
position sensor (S20) is not detected in the specified time when
the saddle stitch alignment plate is moved from a point where
this sensor is turned ON to one point where this sensor is
turned OFF.
The turning ON of the saddle stitch alignment plate home
position sensor (S20) is not detected in the specified time when
the saddle stitch alignment plate is moved from a point where
this sensor is turned OFF to one point where this sensor is
turned ON.
Checking and measures
Check if the electrical continuity of the coil is normal. If
electricity is not conducted, replace the motor.
8 - 201
Error item
Measures
Remarks
Contents
Measure
Measure
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
8