Toshiba e-STUDIO2008A Service Manual page 906

[H] Reinstall license
If the license was returned in "[A]Return License", reinstall it with the following procedure.
(1) Performs FS-08-3840.
(2) Press the [INSTALL].
(3) Install the one-time dongle in the equipment (the one which you used for returning the selected
license before replacing the equipment). Then press the [OK].
(4) Select the license to be installed, and then press the [INSTALL].
(5) The screen for notifying that the installation will be started is displayed. Then press the [YES].
(6) After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK]. If the screen for notifying a failure of the performance is
displayed, quit this operation by pressing the [NO]. Then check that the one-time dongle is
installed properly in the equipment.
(7) Check that the installed license is displayed on the license list.
Remarks:
If there are any other licenses to be installed, repeat from step (2). If there are no other licenses
to be installed, press the [CLOSE], and then turn the power OFF.
[I] Check firmware versions
• System firmware version (FS-08-9930)
• Scanner firmware version (FS-08-9902)
Notes:
If the security mode is changed from High Security to Low Security in the step "[A] Return
License", set the value of FS-08-8911 to "3" (High Security).
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
REPLACEMENT OF PC BOARDS/HDD
© 2015 TOSHIBA TEC CORPORATION All rights reserved
9 - 22